Ford vcm updating dating website optimizer

posted by | Leave a comment

Ford VCM II support multi-language and update via CD.

NOTE: Following module installation, some modules require a separate learning procedure be 3. For adaptive learning and calibration Programming and press the check mark.

In past few years 80% of them are "bad" clones, and unfortunately this ratio grows.

"Bad" clones are not fully compatible with original ELM327 and will not work with FORScan.

it will be used on 2009 and newer trucks and suv,s. as in , when the IDS software was first downloaded,and registered, the next step was to configure the VCM2 with IDS, and it will not do so. The arrow icon in the top right corner should be there even if a VCM2 has never been used.

ford vcm updating-65ford vcm updating-56

also will i have to reset the date and how long will it last and can you post or pm me what you are chaning so hen next version comes out i can do this right away in case ytour not around to do it. not that they cant dl the file here and use file compare and see what it is but pm please...thanks renmeed and it still says service not let it with no file extesin on it as you sent it and it still says service nt avable.

It is 99% of models after 2000 and around 92% of models after 1996 (the year when OBD2 became a standart in USA).

Supported adapters : ELS27 (STN1170/2170) Important note: almost all of adapters sold under "ELM327" label are "clones" (use not original ELM327 chip).

have current version of IDS software, plug in VCM and nothing happens.

Purchased all tooling from Ford, and cannot access troubleshooting for VCM2 !! With all of the information provided there is no reason it should not work.

Leave a Reply

Free chat fuck no sighn up